K-Type Thermocouple with Kapton Insulation 3ft

K-Type Thermocouple with Kapton Insulation for Digital Thermometers

-320 to 752°F    (-200 to 400°C)

This is a reliable thermocouple wire probe with a K-Type thermocouple sensor. The k type sensor is at the tip of a 3ft long wire probe, which has a high temperature Kapton plastic insulation, good up to 752 degree Fahrenheit °F or 400 degree Celsius °C. The wires are AWG 24, or about 0.5 mm. The thermocouple diameter is about 1.5 mm.

The thermocouple has a miniature type connector (2 flat blades) that will work with digital K-type thermocouple thermometers of many manufacturers (Nicety, Fluke, Extech, Omega). This k type thermocouple probe can be used to measure air or gas temperature, non corrosive liquids, many solvents and the sensor can be attached to pipes or embedded into objects you want to measure.

This thermocouple will read very low temperatures, if you have a suitable thermometer. I have tested this down to -350°F (-210°C) with my thermometer DT1311 and DT1312. Some k-type thermocouple thermometers DT804 and DT804A only measure to -58°F.  The miniature K-type thermocouple connector can easily be opened and you can shorten the wire if desired.

Specification:

Thermocouple: K-Type ( chromel / alumel ), ANSI color coded
Temperature Range: -320 to 752 °F     (-200 to 400 °C)
Conforms to the Standard k-type thermocouple error +/- 2.5 degree C or ±0.0075×
Wire length: approx. 3 ft / 36 inch / 95 cm
Probe Diameter: 0.06 inch (1.5mm)
Miniature K-Type connector, can be opened if you want to shorten wire